LS Swap Receiver Drier with GM A/C Pressure Transducer

Application

Any LS Swapped vehicle equipped with Vintage Air or Classic Air.  If your vehicle was equipped with a Receiver Drier from the factory this may work for your application. However, it may require some modification. This part is a direct drop-in for Vintage and Classic Air Systems.  This drier has #6 Male Fittings.

If your vehicle has an accumulator located on the firewall or at the evaporator you CANNOT use this item!

Description

This LS Swap A/C receiver drier is OEM quality. It is also recommended to change the drier every time the A/C system is opened.

The Binary Switch Pressures are set to

High Pressure Cut Off is 400 PSI

Low Pressure Cut  Off is 28 PSI

Why BP Automotive?

BP Automotive is the only LS Swap Standalone Harness Manufacturer that offers and fully supports A/C installation and integration with the GM LS EFI systems.  We will make integrating A/C with our harness and the GM control modules simple. No more stalling at a stop or during a low rpm cruise. No more forcing fans on with extra relays. Your fans and idle controls will work with the A/C just as they would in a factory LS vehicle!

Additional Info

It comes equipped with both a GM A/C Pressure sensor and a binary switch for compressor protection. It comes with switches uninstalled. Install switches, snug them, then check for leaks.

 ack-010 ack01010