Our harnesses are designed for installing these new GM EFI engines into your ride, whatever it may be. This harness is specific for 1999-2007 4.8, 5.3, and 6.0 Vortec engines with RPO Codes LR4, LM7, L59, LM4, LQ4, and LQ9 with a Drive by Wire (Electronic) Throttle Body and Multec Injectors. All harnesses are made with GM color coded TXL wire to meet or exceed OEM standards! All circuits that are ran by heat like the O2 sensor circuits are covered with 1200* Fiberglass Braid. We only use Delphi, Kostal, Bosch, Molex, and Yazaki connectors, terminals, and seals on our harnesses, just like an OEM harness. All connectors that have Connector Position Assurance Lock on a factory harness have them on our harnesses also. The harnesses also include a Delphi Grommet that can be positioned on the main harness line to seal your firewall. Harnesses are 5 foot long from the rear of the intake. This enables you to mount the PCM and Fuse Block in the passenger compartment. Harnesses are for pre-emissions vehicles or for off road use only. Harnesses do not have provisions for EGR, AIR, EVAP, or Rear O2 Sensors. We can add these for an additional cost, however in most cases they are not needed. IF EMISSIONS ARE NEEDED YOUR HARNESS WILL INCUR A LEAD TIME. Harnesses also require the removal of the VATS system from the PCM as well as the emissions removal from the PCM. BP Automotive offers this service as well. This harness also requires the use of a Blue and Green PCM from a 2003-2007 application, also available through BP Automotive., also available through BP Automotive. This application uses an Electronic Automatic Transmission applications which will also require a double pole brake switch for converter lock up control. This is also available here at BP Automotive, P/N TCC-001.
***Current Lead Time Approximately 1-3 Business Days***
h355 h-355 8355