#8 Standard Barrier Crimp In Fitting with GM Sensor

When doing a LS Swap and using A/C you need to integrate the GM pressure sensor so you can bump the idle and operate the cooling fans when your A/C is on.  This kit will enable the use of a GM Sensor that will send your ECM or PCM the information it needs to operate your Swap properly when the A/C is on.

This fitting is made of Steel is for a #8 Standard Barrier A/C Hose that is found on most aftermarket A/C systems.  If you are unsure if your hose is #8 you can use the following measurements to determine if it is.

The threads are M10X1.25.

#8 13/32” I.D. , 29/32” O.D. HOSE (COMPRESSOR DISCHARGE HIGH PRESSURE HOSE)

If you are looking for a Weld in fitting for a GM pressure sensor purchase BP Automotive part number ACF-001

If you are looking for a Weld in fitting and a GM pressure sensor purchase BP Automotive part number ACK-001

If you would like to purchase just the Binary Switch purchase BP Automotive part number ACS-002

If you are looking for a crimp in fitting with a 7/16 Port for a Binary Switch purchase BP Automotive part number ACF-006