2005-2006 Gen IV Standalone Flash For E40 ECM (Engine Control Module)
This is a reflash service for a ECM YOU PROVIDE. ECM Pictured is NOT included. We remove all of the factory components that will not be used for standalone operation and tune for your application.
***Customer is responsible for shipment of ECM to BP Automotive. We do not provide a shipping label for you!***
BE ADVISED: We only offer tuning for customer’s using our products!
Service Numbers covered by this item include – 12578554, 12597883, 12596679
It is impossible to tune any application perfectly when performing a “mail order tune”. No two engines run exactly alike. Most factory, non modified engines will run as they should. However, even a swap with a factory engine will benefit greatly from a dyno tune – especially if you are running a 4L60E or 4L80E.
All modified applications which includes anything from cam only to heavily modified will be considered a START UP TUNE ONLY!
All applications we tune can experience small drive-ability issues or a slightly higher idle. These can range from a stall on sudden stops to bucking under very slow cruising speed. While most do not experience anything like this, some do.
BP Automotive HIGHLY stresses the importance of a dyno tune. This is where the vehicle can be tailored to run exactly how you want. It is impossible for us to achieve the same results in a “Mail Order Tune”.
This item requires that you fill out our tuning form, failure to fill out the tuning form will result in a delay in your order. The tuning form is below and does require an invoice number, please fill it out once you add this item to your cart and pay for your order. Filling out the tuning form is not a substitute for placing an order!
BP Automotive is not responsible for any form that is filled out incorrectly.
By filling out the form below you are agreeing to the above conditions.
2005-2006 Gen IV Standalone Flash For E40 ECM e40 e40 programming e40 tune tune